Teac MX-View Version 1.0b1 User Manual download pdf (Page 58)

6-24 Reverse

Reverse “reverses” an audio event or region, as if audio was played backwards, without

affecting unselected tracks. The newly reversed audio event will replace the existing

audio region. To perform a Reverse, select the desired events or audio region and select

Reverse under the Edit Menu. Depending on the length and number of tracks selected, a

Reverse may take up to a few minutes to process. The busy cursor will appear during this

process.

Before:

After:

6-25 Undo and Redo

The MX-2424 has 99 levels of undo, meaning it can undo the last 99 edits or recordings

performed. Undos are only valid in the existing project, meaning you cannot perform an

undo on a previous project. Undos are not stored with the project - the Undo list is

cleared each time you start a new project, unmount a disk, or turn off the recorder. Press

Redo to go back an Undo level. Undo and Redo functions are available on the Edit bar,

Edit menu, or as quick key short cuts.

Undo: Ctrl + Z on Microsoft Windows, Cmd + Z on Macintosh

Redo: Ctrl + Y on Microsoft Windows, Cmd + Y on Macintosh



Note:

The MMR is limited to 10 levels of undo.

6-26 Drag and Drop Editing

Drag and drop editing allows you to use the mouse, in conjunction with various keyboard

short cut keys, to edit and move audio events around with great flexibility. While the

Selector Tool is used mostly to select audio regions, the Drag and Trim Tool can trim

events and fades, move and drag audio events, insert and edit volume automation

breakpoints, and move location markers (Breakpoint volume automation and Event and

Fade trimming are covered in Chapter 7).

Audio Event is

selected

Reverse edit is

performed, the

waveform reversed.

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 91 92

No comments

Teac MX-View Version 1.0b1 User Manual Page 58