Teac CD-601MKII User Manual download pdf (Page 7)

TASCAM CD-601MKII 7

INTRODUCTION

About Backup Memory

The following setup information is stored to backup

memory on the CD-601MKII so that the same settings are

reproduced when this product is next turned ON.

• Playback mode

• Time display mode

• Auto ready function ON/OFF

• Auto cue function ON/OFF

• Pitch control function ON/OFF

• Pitch control value

• Index search function ON/OFF

• Settings for each of the menu items (*)

(*) : When the “USER” menu is set to “PRE”, the menu

item settings return to their defaults each time that

the power is turned ON. (→ page 19 “Saving Menu

Settings”)

Precautions upon Use

About the power supply

Connect this CD player to the specified power supply. Do

not connect to other power supplies.

When connecting or disconnecting the power cable, hold it

by its plug.

Daily care of the CD player

Do not wipe the CD player’s body with chemical-

impregnated cloth, or a cloth soaked with benzene, paint

thinner or other organic solvent. Doing so might damage the

surface of the CD player’s body. Wipe off stubborn dirt on

the top cover or panels with a soft cloth moistened with a

small amount of diluted neutral detergent.

About condensation

When the CD player (or a compact disc) is moved from a

cold to a warm, heated room (e.g. in winter), or immediately

after heating apparatus in the room where the CD player is

installed is turned ON, water droplets (condensation) may

form inside the CD player. This will not only prevent the

CD player from operating normally but also may damage

discs or precision components inside the CD player. If

condensation forms, leave the CD player turned ON for

one or two hours to acclimatize and allow water droplets

to evaporate so that the CD player can operate normally.

Before moving the CD player or when the CD player is not

used, remove the disc.

Handling CDs (compact discs)

This CD player can play back CD-DA format CDs.

Both commercially available audio CDs (120 mm/80 mm)

and normally recorded CD-R/CD-RW discs can also be

used.

z To take a disc out of its storage case, press down on the

centre of the case and lift the disc out, holding it carefully

by its edges.

Correct way of taking Correct ways of holding

a compact disc out of a compact disc

its storage case

z Fingerprints or dust on the recording surface should be

carefully wiped off by wiping in a straight motion from the

inside to the outside of the disc with a soft cloth. Dirt on

discs causes the laser pickup to jump. So, keep discs in

a clean state at all times and store them in their storage

cases.

z Never use record sprays, antistatic sprays, benzene,

paint thinner, or other organic solvents. Chemical

products such as these may damage the surface of the

disc.

z Do not expose discs to the direct sunlight or high

temperature or humidity. Long exposure to high

temperatures may cause them to warp or become

deformed.

z Do not stick paper or write anything with a ballpoint pen

on the label surface.

z Do not use discs from which cellophane tape or rental

CD stickers have been peeled off, or discs with adhesive

from stickers still sticking to the disc. Leaving discs such

as these in the CD player may prevent the disc from

being removed or cause a malfunction.

CD-601MKII_Eng.indd 7 3/26/2005 7:39:45 PM

1 2 3 4 5 6 7 8 9 10 11 12 ... 28 29

Comments to this Manuals

No comments

Teac CD-601MKII User Manual Page 7

Comments to this Manuals

Related products and manuals for Players Teac CD-601MKII