Teac SX-1:SX-1LE Documentation Sony P2 Protocol User Manual

TASCAM TEAC Professional Division SX-1 Digital Production Environment SX-1 Version 1.50 Sony P2 Protocol Documentation This manual describes

tracks is assumed to be 0. If there is no audio take currently assigned to an HDR destination channel that is requested to be in EDIT mode (bit = 1),

BIT 7 6 5 4 3 2 1 0DATAMSB LSB0VIDEO REFMISSING1STANDBY STOP REW F.FWD REC PLAYON2SERVO SHUTTLE JOG VAR REVERSESTILL CUE UP LOCK DIR ENDED34SELECT EEF

DATA 1/BIT 2: F.FWD This bit is set when the SX-1 HDR is fast-forwarding. DATA 1/BIT 1: REC This bit is set when the SX-1 HDR has any tracks that are

DATA 4/BIT 6: FULL EE ON This bit is set whenever all 16 HDR channels have INPUT monitor ON. This can happen during record, or when the FULL EE ON com

If more than 3 data bytes are requested, data bytes above DATA 2 will contain zero. *15 CURRENT TIME SENSE: The SX-1 will reply to all requests for t

Appendix No. Type Name Recs No. Type Name Recs No. Type Name Recs1 0x0001BVH-20002 51 0x1002BVU-850-- 101 0x3003OMX-24-- 2 0x0010BVH-20002 52 0x10

No. Type Name Recs No. Type Name Recs No. Type Name Recs151 0xa011LVA-3000-- 201 0xd051 DADR-5032 32 251 0xf012AbekasA82-- 152 0xa020CDP-3100--

Additions: P2 Master reads and uses Rec-arm tally messages. In V1.00 and V1.10, the SX-1 does not send out requests for EDIT PRESET STATUS, or use th

exiting MixDown and loading the MixDown takes. P2 Slave support. V1.50 adds the ability to control the SX-1 from an external device using the P2 prot

Sony P2 Specifications. Timing: The SX-1 will reply to incoming commands within 9ms. The time required to actually execute the command and update the

From Controlling device Return from SX-1Command CMD 1 CMD 2 DATANAME CMD1 CMD 2 DATATIMER-1 PRESET 44 00 *5 ACK 10 01 *1EDIT PRESET 41 30 *11 ACK 10 0

At 25 Frame (PAL/SECAM), the value 0100 is added to the reply data. (F01A->F11A, etc) At 24 Frame (FILM), the value 0200 is added to the reply d

*5 Cue Up With Data Format Binary coded decimal (BCD) format with Frames first. 10FR FR 10SEC SEC 10MIN MIN 10HR HRMSD LSD MSD LSD MSD LSD MSD LSDBi

If there is no valid VIDEO or TTL signal being received by the SX-1, then the command will be executed during field 1 of the calculated frame. The fra

*9 DMC SET: The SX-1 does not support Dynamic Motion Control, but it recognizes the DMC SET FWD and DMC SET REV commands. The SX-1 will treat them the