Teac HD-1 User Manual download pdf (Page 12)

Listening to the Radio

Extend the FM wire antenna fully for best reception (do not strip,

alter or attach to other antennas). The AM loop antenna should

be placed up to 12" away from the unit for best reception.

Rotate the AM loop antenna as required for best reception.

Press the STANDBY/ON button to turn on the unit.

Press the FUNCTION/WAKE TO button on the HD-1 to

select AM or FM band to listen to the radio. The radio

frequency appears at the center of the display.

Turn the TUNING/SELECT knob on the HD-1 (or press

.or / on the remote control) to tune in the desired

station. Press and hold the . or/ on the remote

control for 2 seconds to Auto scan to the next clear station.

Storing Preset Stations

This unit allows you to program 20 stations on FM band and

10 stations on the AM band.

Turn the TUNING/SELECT knob on the HD-1 (or press .

or/ on the remote control) to tune to the station you

wish to store.

Press the MEMORY button once to store the station.

While preset number indicator flashing on the display, press

PRESET button repeatedly to select preset station.

Press MEMORY button again to confirm after your preset

number selected.

To store more stations, repeat steps

How to select a preset station

To select FM or AM, press the FUNCTION/WAKE TO

button.

Press the PRESET button on the unit repeatedly until the

desired preset station is found.

NOTE :

•

If the preset memory mode is open and no button is pressed

for 10 seconds, the preset memory mode will quit unless

the MEMORY button is pressed before then to confirm and

close the preset memory mode. No frequency will be stored

after the 10 seconds runs out.

HD-1.indd 12 2008.12.17 9:19:34 AM

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

No comments

Teac HD-1 User Manual Page 12