Teac AD-RW900-B User Manual Page 10

  • Download
  • Add to my manuals
  • Print
  • Page
    / 148
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 9
10
Connections
Automatic tape type detection function
This cassette deck can detect what type of tape is being used based
on the detection holes in the cassette shell. Be sure to use cassettes
with detection holes.
Metal
(
Type
)
Chrome
(
Type
)
Normal
(
Type
)
Automatic tape type
detection holes
Accidental erasure prevention tabs
Tabs in the top of the cassette shell allow you to prevent important
recordings from being erased by mistake. There are two tabs in each
cassette shell—one for “side A and one for “side B.
Once these tabs have been removed using a screwdriver or similar
tool, there is no chance of the recording function being activated by
accident.
Accidental erasure prevention
tab
for “side A”
“side A”
< To record on a cassette that has had its tab broken off, cover the
hole using a piece of adhesive tape. Be careful not to block the
tape type detection holes.
Dolby NR (noise reduction)
Dolby NR is designed to reduce tape hiss, which is noise introduced
during the recording and playback processes. This cassette deck is
equipped with Dolby B-type noise reduction.
Use the DOLBY NR switch to turn the Dolby NR on and off.
< The Dolby NR system affects both recording and playback quality.
For playback, be sure to set the DOLBY NR switch to the same
position used when the recording was made.
Cassette Tapes (2)
Voltage Selection
(General export/North America models only)
Q Be sure to remove the power cord from the AC outlet before
changing the position of the voltage selector switch.
1. Locate the VOLTAGE SELECTOR switch on the rear panel.
2. Using a flat-bladed screwdriver, set it to the appropriate position
(230V or 120V) for the power supply used in your area.
IN NORTH AMERICA USE ONLY ON 120V SUPPLY.
Notes on turning on or off the power
When an amplifier is connected to the AD-RW900, turn on or off
the power of the AD-RW900 and the amplifier in the following
sequence.
When turning on the power
1. AD-RW900
2. Amplifier
When turning off the power
1. Amplifier
2. AD-RW900
Page view 9
1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 147 148

Comments to this Manuals

No comments