Teac MCDV600 User Manual download pdf (Page 36)

VIDEO OUTPUT

This setting is for selecting the output terminal of the video. You can

select “S-VIDEO” (S-video output) or “Y Cb/Pb Cr/Pr” (Component

video output).

S-VIDEO

Select this if you have connected the unit to your TV using S-Video

jack.

Y Cb/Pb Cr/Pr

Select this if you have connected the unit to your TV using

Component video jacks.

< When your TV is connected to the HDMI terminal, no signal is

output from the component video output jacks.

TV MODE

This setting allows the selection of interlaced (INTERLACE) or

progressive-scan (PROGRESSIVE) video from the component video

outputs.

Progressive-scan video provides a better, clearer picture. However, it

is not supported by every TV or monitor, and you should ensure that

this is supported fully before turning on this option.

< When your TV is not compatible with progressive scanning,

never select “PROGRESSIVE”. Otherwise, a picture is distorted

or no picture will be shown on the monitor.

In case you select “PROGRESSIVE” by mistake, disconnect the

connection of the MC-DV600 and the TV, and then connect in

again. And change the setting to “INTERLACE” in the VIDEO

SETUP menu.

Consumers should note that not all high definition TV sets

are fully compatible with this product and may cause artifacts

to be displayed in the picture. In case of 480 (525) or 576 (625)

progressive scan picture problems, it is recommended that the

user switch the connection to the ‘standard definition’ output. If

there are questions regarding our TV set compatibility with this

model 480p (525p) and 576p (625p) DVD player, please contact

our customer service center.

COLOR SETTING

You can adjust some parameters of video picture.

Highlight “COLOR SETTING” and press the right (

)

button.

Use the left and right (

) buttons to select the

parameter.

SHARPNESS

This adjusts the sharpness of the picture shown on the monitor.

Select HIGH, MEDIUM or LOW using the Cursor buttons, then

press the ENTER button.

BRIGHTNESS

This adjusts the brightness of the picture.

Use the left and right buttons to change the value from –20 to

20, then press the ENTER button.

CONTRAST

This adjusts the picture contrast.

Use the left and right buttons to change the value from –16 to

16, then press the ENTER button.

GAMMA

This adjusts the gamma value of the picture.

Select HIGH, MEDIUM, LOW or NONE using the Cursor buttons,

then press the ENTER button.

HUE

This adjusts the green/red balance of the picture (only for

progressive-scan output).

Use the left and right buttons to change the value from –9 to 9,

then press the ENTER button.

SATURATION

This adjusts the saturation level.

Use the left and right buttons to change the value from –9 to 9,

then press the ENTER button.

LUMA DELAY

This adjusts the luma delay.

Select 0 T or 1 T using the Cursor buttons, then press the ENTER

button.

Press the left (

) button to return to the VIDEO SETUP

Page.

Settings (VIDEO SETUP)

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 47 48

Comments to this Manuals

No comments

Teac MCDV600 User Manual Page 36

Comments to this Manuals

Related products and manuals for Acoustics Teac MCDV600