Teac DV-RA1000HD User Manual download pdf (Page 56)

8 − Effects

56 TASCAM DV-RA1000HD

The output level from the EQ effect (which

feeds the dynamics processor) is shown by

the meters at the right of the response curve.

•

NOTE

Since each band is capable of boosting the level by

12 dB in the digital domain, you should take care

not to overload the outputs.

Press

ENTER

to conrm these settings.

For each band of the processor, the following

parameters are available (the screen shows the

setting, and in many cases, a graphic changes to

reect the changes made to the parameter val-

ue). Use the

and

keys to navigate, and the

JOG/DATA

dial to change values.

THRESHOLD: The input signal level at which the

compressor/expander starts to operate.

RATIO: The ratio between the original and pro-

cessed signal levels.

KNEE: The shape of the change before and

after the signal reaches the threshold level.

•

Dynamics processor

The dynamics processor has a number of settings avail-

able:

Three-band compressor

Three-band expander

Single-band compressor

Single-band expander

The frequencies of the two crossover points of the

three-band effects can be set (the slope of the filters is 6

dB/octave).

The dynamics processor always comes after the EQ

effect.

1 From the effect setting screen (see Figure 8.1, Ef-

fect setting screen), press the F2 (DYN) key.

Figure 8.3: Dynamics crossover screen

•

2 The rst parameter, TYPE, allows you to select the

type of dynamics processor, as explained above:

CMPx3, EXPx3, CMPx1, EXPx1.

3 On this screen, use the F1 and F2 keys (up and

down) and the JOG/DATA dial to set the crossover

points for the dynamics bands (this only has an

effect when CMPx3 or EXPx3 is selected).

These two frequencies cannot overlap.

CMPx1 is selected, the MAKE UP (makeup gain)

parameter can be turned ON or OFF here.

4 Press F3 (BAND) to make the settings for the dy-

namics processor. For CMPx3 and EXPx3

settings, repeated presses of the F3 key cycle

through LOW, MID and HIGH bands. There is only

one setting screen and one set of parameters,

named SINGLE, for the single-band processors.

Figure 8.4: Dynamics processor band settings

Threshold

Dynamics

setting

Input level

Gain

Attack &

release

Output

level

Gain

reduction

Threshold

Dynamics

setting

Input level

Gain

Attack &

release

Output

level

Gain

reduction

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 67 68

Comments to this Manuals

No comments

Teac DV-RA1000HD User Manual Page 56

Comments to this Manuals

Related products and manuals for Players Teac DV-RA1000HD